The FAA found dozens of violations in Boeing’s production processes – Kommersant
[ad_1]
During a six-week audit of Boeing 737 Max production, the US Federal Aviation Administration (FAA) found dozens of violations. Writes about this The New York Times (NYT), which obtained documents related to the inspection.
The documents show that the FAA conducted 89 inspections of various 737 Max manufacturing processes, of which only 56 were successful. In 33 cases the checks were not completed. Another 13 inspections were conducted against the company’s component supplier, Spirit AeroSystems; 6 of them were passed, 7 were not.
Checks began after incident in early January, when the emergency exit hatch cover on an Alaska Airlines Boeing 737 MAX 9 fell off, causing the cabin to depressurize.
The FAA inspected a wide variety of manufacturing processes related to the fuselage, wings and other aircraft systems. According to the NYT, some of the violations found related to quality control documentation, and many related to non-compliance with “approved manufacturing processes, procedures and instructions.” For example, in some cases, when adjusting the door and checking quality, ordinary liquid soap and a hotel key card were used, which was not specified in any instructions. The FAA said it could not release the audit data due to ongoing investigations.
Earlier, during inspections, it turned out that many Boeing 737s had hatch plugs installed improperly, and also that there were Problems with fuselage. At the end of February, the company fired Ed Clark, head of the 737 MAX program. Last week became knownthat the US Department of Justice is also investigating Boeing over the January incident.
[ad_2]
Source link
